There are 2 different gain faders that serve different purposes: Learn more and download at When to Use the Channel and Automix Gain Faders Select your device in the list and click Configure to open the device's configuration window.
Download and install Designer on a computer connected to the same network as your device.Create and reuse templates across multiple locations and projects.Control Shure device settings and coverage.Design audio coverage, whether online or offline.Designer enables integrators and system planners to design audio coverage for installations using MXA microphones and other Shure networked components. You can control this device using Shure Designer software. If you remove or add devices, select Optimize again.Ĭontrolling Devices with Shure Designer Software
Designer optimizes microphone and DSP settings for your equipment combination. Verifying that AEC reference signals are correctly routed.You can customize settings further, but the Optimize workflow gives you a good starting point.Īfter optimizing a room, you should check and adjust settings to fit your needs. The settings are optimized for your particular combination of devices. Enables LED logic control for applicable devices.Creates audio routes and mute control routes.When you select Optimize in a room, Designer does the following: Optimize also creates mute control routes in rooms with MXA network mute buttons. Dante™ Virtual Soundcard enables audio monitoring and recording directly on the computer.ĭesigner's Optimize workflow speeds up the process of connecting systems with at least 1 microphone and 1 audio processor. Route audio with Dante™ Controller or Shure Designer software. You can remotely control coverage, muting, LED behavior, gain, and network settings. Analog loudspeakers and amplifiers connect through a Shure Network Interface (model ANI4OUT), which converts Dante™ audio channels into analog signals, delivered through 4 discrete XLR or block connector outputs.Ī computer running Dante Controller and Shure Designer provides control over the following:Ī computer connected to the network controls the microphone with Shure Designer software. ③ Far-end audio (network to loudspeakers)ĭante™-enabled loudspeakers and amplifiers connect directly to a network switch. A single network cable delivers 4 discrete audio channels from each microphone onto the Dante network, where they can be routed to any Dante-compatible devices.Īnalog equipment, such as a wireless microphone system or a gooseneck microphone on a podium, connects to the Dante™ audio network through a Shure Network Interface (model ANI4IN) for a completely networked conferencing system.
0 kommentar(er)
